What are the pros and cons of three stainless steel truck door locks?

Door lock stainless steel polishing notes:

Grinding with sandpaper or abrasive tape in the grinding operation is basically a buffing operation, leaving a very fine grain on the surface of the steel sheet. There have been problems with using alumina as an abrasive, in part because of pressure problems. Any abrasive parts of the equipment, such as: abrasive belts and grinding wheels, should not be used for other non-stainless steel materials before use. Because it will contaminate the stainless steel surface.

In order to ensure the consistency of the surface processing, the company's new grinding wheel or belt should be tested on the same waste to compare with the sample.

Advantages and disadvantages of stainless steel polishing methods for three door locks.

The commonly used polishing methods for stainless steel door locks include mechanical polishing, chemical polishing, and electrochemical polishing. These three methods each have their own advantages and disadvantages.

1.Van truck lock Mechanical polishing.

The advantage is that the finished part has good leveling property and high brightness. The disadvantages are that the labor intensity is high, the pollution is serious, and the complicated parts cannot be processed, and the gloss cannot be consistent, the gloss is not kept for a long time, and the stagnation and rust are caused. More suitable for processing simple, medium and small products.

2. Chemical polishing.

The advantage is that the processing equipment has less investment, the complicated parts can be thrown, the speed is fast, the efficiency is high, and the corrosion resistance is good. The disadvantage is that the brightness is poor, there is gas overflow, ventilation equipment is needed, and heating is difficult. It is suitable for processing small batches of complex parts and small parts with low brightness requirements.

3, electrochemical polishing

The advantage is that the specular gloss is kept long, the process is stable, the pollution is small, the cost is low, and the corrosion resistance is good. The shortcomings are high anti-pollution, large investment in processing equipment, complicated tools, auxiliary electrodes, and mass production facilities. Suitable for mass production, mainly used in high-grade products, export products, tolerance products, stable processing technology and simple operation.